Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHECK ON FOOD
An audible signal will sound and the display shows
the action to be done. Check the food, close the door
and press
or
to continue cooking.
Please note: Press
to skip these actions. Otherwise, if no
action is done after a certain time the oven will continue
the cooking.
6. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press
to continue cooking in manual mode
(untimed) or press
setting a new duration. In both cases, the cooking
parameters will be retained.
BROWNING
Some functions of the oven enable you to brown
the surface of the food by activating the grill once
cooking is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press
to start a five-minute browning
cycle. You can stop the function at any time by
pressing
to switch the oven off.
. MY FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10
on your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once
has been pressed, press the
the number position, then press
Please note: If the memory is full or the number chosen has
already been taken, the oven will ask you to con rm
overwriting the previous function.
To call up the functions you have saved at a later
time, press
: The display will show your list of
favorite functions.
to extend the cooking time by
.
or
to confirm.
1. CONVENTIONAL
Press
or
pressing
. CLEANING
•
DIAMOND CLEAN
Press
Diamond Clean
Press
prompt you to do all actions needed to obtain the
best cleaning results: Follow the indications and then
press
when required press
cycle.
Please note: It is reccommended to do not open the oven
door during the cleaning cycle to avoid a loss of water
vapor that could get an adverse e ect on the nal cleaning
result.
An appropriate message will start flashing on the
display once the cycle has finished. Leave the oven to
cool and then wipe and dry the interior surfaces with
a cloth or sponge.
•
AUTOMATIC CLEANING PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished
airing) running the Pyro cycle.
Remove all accessories - including shelf guides - from
the oven before activating the function. If the oven is
installed below a hob, make sure that all the burners
or electric hotplates are switched off while running
the self-cleaning cycle. For optimum cleaning results,
remove excessive residuals inside the cavity and
clean the inner door glass before using the pyrolytic
function. We recommend only running the Pyro
function if the appliance contains heavy soiling or
gives off bad odours during cooking.
Press
to show "Pyro" on the display.
to select
Pyro
Press
or
to confirm. Once a cycle has been selected, if
desired, press
then press
all accessories as prompted, then close the door and
press
cleaning cycle, while the door locks automatically:
a warning message appears on the display, along
to select the function, confirm by
, and then press
to show "Diamond Clean" on the display.
to activate the function: the display will
when done. Once you have done all steps,
to activate the cleaning
to select the desired cycle, then press
or
to set end time (start delay),
to confirm. Clean the door and remove
when done: the oven will begin the self-
to activate.
Werbung
