Assa Abloy ZIKON +CLIQ Bedienungsanleitung Seite 39

Installation of the
+CLIQ mechatronic locking cylinder
Cylinder fixing screw length
A 85 mm long cylinder fixing screw is suitable for locks with a backset of
up to 75 mm. The following applies to locks with a larger backset:
Length of the cylinder fixing screw = backset size + 10 mm.
Installing the profile c ylinder
Prerequisite: The mortise lock must be completely installed.
Observe the installation instructions with figures („Figures", page 90).
An optional change of the cam position is possible with profile cylinders
(„Changing the position of the locking cam", page 91).
1 Insert the profile cylinder into the profile cylinder cutout.
2 Fix the profile cylinder in place with the fixing screw.
The cylinder fixing screw supplied is suitable for locks with a backset
of up to 50 mm. The following applies for locks with a larger backset:
Length of the cylinder fixing screw = backset + 10 mm.
3 Only hand-tighten the cylinder fixing screw. (max. 3.5 Nm).
4 Test the locking cylinder for correct function and ease of movement.
For this purpose, actuate the locking cylinder several times with the
appropriate key.
 You have installed the profile cylinder.
Cylinder mounting EN 39