Bosch Climate Class 6000i Serie Bedienungsanleitung Seite 16

Operation
The fan speed cannot be adjusted in automatic mode or
dehumidification mode.
Switching the appliance off
▶ Press the Stop button.
The green operation lamp K turns off.
3.8 Eco operation mode
The air conditioner will operate with lower power consumption than
usual in this mode.
▶ During operation, press the Eco button to reduce power
consumption.
The remote control displays
active.
To cancel the operation mode:
▶ Press the Eco button again.
3.9 Plasmacluster mode
Plasmacluster ions released into the room are effective against airborne
contaminants, such as mold, viruses, and allergens.
▶ During operation, press button.
The remote control displays
The blue plasmacluster lamp on the unit lights up.
To cancel:
▶ Press button again.
The blue plasmacluster lamp on the unit turns off.
NOTICE
▶ Use of the plasmacluster mode will be memorized, and it will be
activated the next time you turn on the air conditioner.
▶ To perform the plasmacluster mode with fan only mode, press the
plasmacluster button while the unit is not operating. The operation
mode symbol at the top left on the remote control will disappear and
the fan speed can not be set to auto.
3.10 Full power mode
In this operation mode, the air conditioner works at the maximum power
to rapidly heat or cool the room.
▶ During operation, press the
The remote control displays
To cancel full power mode:
▶ Press the button again.
The unit returns to its original settings.
Full power mode will automatically cancel after one hour.
You can not set the temperature or fan speed during full power mode.
16
while the operation mode is
.
button.
and the temperature disappears.
3.11 Other functions
3.11.1 Setting the swing function
NOTICE
If the louvres remain in the lowest position in cooling or drying mode for
an extended period, condensate may be discharged. Adjusting the
louvres by hand may cause faults.
▶ Only use the remote control to adjust the louvres.
Vertical Swing mode
▶ Press the button to set the desired airflow direction.
The adjustment possibility of the combustion air supply depends on the
operation mode selected:
• In cooling or drying mode, the combustion air supply can also be
directed to the ceiling.
• In heating mode on the other hand, the combustion air supply can be
selected for the underfloor
• Automatic mode does not allow any flow settings to the ceiling or
underfloor.
The setting AUTO has the following behaviour:
• Cooling mode: the airflow direction will be set obliquely downward,
and then shifted to horizontal or obliquely upward to direct cool air at
the ceiling.
• Heating mode: the airflow direction will be set obliquely upward
when the extract air temperature is low, then shifts to obliquely
downward when the extract air becomes hot.
• Dry mode: the airflow direction will be set obliquely upward.
Horizontal Swing mode
▶ Press the button to set the desired airflow direction.
3.11.2 Timer operation
Set 1-2-3-5h off timer
When the 1-2-3-5h off timer is set, the unit will automatically turn off
after the set hours.
▶ Press the button to set the desired time.
The orange timer lamp on the unit will light up.
The remaining time will be indicated on the remote control in 1-hour
increments.
To cancel the timer:
▶ Press the Set/C button or the
The orange timer lamp on the unit will turn off.
The current clock time will be displayed on the remote control.
Climate Class 6000i/8000i – 6721831490 (2020/11)
0010035536-001
0010031001-001
0010030499-001
button.