Kerbl EasyProtect 70590 Bedienungsanweisung Seite 19

9. Cleaning/maintenance
CAUTION!
Risk of physical injury and material damage if used incorrectly!
• Before starting any cleaning work, disconnect the mains plug.
Ensure that the slider moves easily at all times. Clean the guide rails, and apply lubricant if necessary. Remove dirt and any objects from the
slider's closing range, in order to protect the motor and avoid transporting dirt via the cord into the inside of the electronics unit. Regularly check
the condition of the cord for wear,
and replace it in good time. Use our replacement cord to do this (Item 70552).
10. Maintenance and repair
The device does not require maintenance, but should be thoroughly cleaned at regular intervals. In the event of a fault, the device must be taken
out of use
immediately. If a repair is required, please contact a qualified electrician, or send the device to the manufacturer for repair. A faulty connecting
cable should be replaced only by the manufacturer or a qualified electrician. Use only genuine spare parts. If a battery symbol appears on the
display, the batteries must be replaced. After replacing the batteries, the time and date must be re-set (see section 8.1).
11. Errors and possible solutions
Error pattern
Door does not open and close
depending on the time
Door does not open and close
depending on the light sensor
Door does not move down
Door does not move right to the
top, and always jams at the same
position or
Door does not close completely,
and always jams at the same
position
Door moves at the wrong times
Door does not open, and collides
with locking bolt.
Possible cause
Timer is deactivated (time does not advance on the
display, and 't-off' is shown)
The light sensor prevents the door opening,
because it is still dark (closed state always has
precedence)
Automatic mode is not activated (automatic mode
is indicated by a small circle at the top of the
display)
Light sensor is not set properly
Automatic mode is not activated (automatic mode
is indicated by a small circle at the top of the
display)
Too little weight on the cord because
• the door is jamming and therefore does not pull
downwards
Door is obstructed, making it difficult to move (for
example: dirt in the guide rail)
Current time set incorrectly
Opening and closing times not set for weekends
The battery is too weak.
The solenoid is defective.
Solution
Hold down the Menu and OK buttons at the
same time for 5 seconds
Unplug light sensor or else set light sensor
correctly
• press arrow upwards when door is open
• press arrow downwards when door is closed
Wait until the brightness conditions exist at which
you wish to close. Then save this brightness level,
using the appropriate menu option (see section
8.3).
• press arrow upwards when door is open
• press arrow downwards when door is closed
• apply lubrication
Door must be smooth-running.
• remove dirt
• apply lubrication
Time correctly set in the menu
The correct times must be set in the menu for both
weekdays and weekends
Replace the batteries
Contact the dealer.
19