Operation; Led Indication; Overview Of Functions - ANSMANN COMFORT SMART Bedienungsanleitung

§Do not attempt to charge non-re-
chargeable batteries.
§Always place the product on a flat,
stable and heat-resistant surface.
§Do not use the product near flam-
mable liquids or gases.
§Make sure that the ventilation slots
on the bottom housing of the char-
ger are not covered.
§Do not leave the product unatten-
ded during use.
Only use the product in dry
indoor areas and protect it from
moisture.
PRODUCT DESCRIPTION (SEE PAGE 2)
A: Charging compartment
B: Opening to allow for the easy removal of the batteries
C: Multi-colored LED display (red, orange, green)
D: USB power supply connector

OVERVIEW OF FUNCTIONS

Quick charger with USB input for 1-4 NiMH batteries of the sizes Micro
AAA / Mignon AA incl. USB cable
Microprocessor controlled charging with single cell monitoring
Automatic start of charging and charging current adjustment after
insertion of the batteries with correct polarity
Status indication via 3-colour LED per charging slot
Intelligent "PERFECT 7 CHARGING" function (SEE PAGE 2):
Deutsch | English | Français | Español | Português | Svenska
12
Italiano | Nederlands | Dansk | Suomi | Norsk
1. Capacity quick test: Residual capacity is determined
before charging begins and displayed for 5 seconds
2. Gentle pre-charging: Weak or deeply discharged battery is
pre-charged with lower current if necessary
3. Battery analysis: Battery behavior is analyzed and
evaluated to determine whether it is still reliably usable or
defective
4. Quick charge: Battery is charged at maximum current
5. IQ switch-off: Intelligent monitoring of the battery for
reliable charging and multiple protection against overcharging
6. Top-off charge: Ensures that the battery is gently charged
to 100% capacity
7. Trickle charge: Battery is kept in a fully charged state by
means of charging pulses

OPERATION

§ Connect the charger with the included USB cable.
§ Connect the USB cable to any suitable USB port (e.g. power
supply, PC, Power bank...).
§ Insert the battery into the charging slot with the correct polarity
(see engraving in the charging slot).
§ The product displays the charge status of the battery for 5 seconds
and then automatically starts the charging process.
§ As soon as a battery is fully charged, the charger switch to trickle
charge.
§ You can now remove the fully charged battery.
§ After all batteries have been removed, disconnect the product from
the power supply

LED INDICATION

Capacity indication (for the first 5s
after insertion)
Charging
Error
Full / trickle charge
Pause (*1)
Deutsch | English | Français | Español | Português | Svenska
Italiano | Nederlands | Dansk | Suomi | Norsk
Red Orange Green
<25% 25-75% >75%
On
Flashing
On
Flashing
13