Palmer supreme soaker Bedienungsanleitung Seite 5

USER MANUAL
1. To disconnect the device completely from the power supply, unplug the power cable or the power
adapter from the socket. It is not sufficient to press the on/off switch on the device. In addition, a
connected amplifier must also be disconnected from the device!
2. Make sure that the fuse used corresponds to the type printed on the device.
3. Ensure that suitable measures have been taken against overvoltage (e.g. lightning strikes).
4. Observe the specified maximum output current on devices with a Power Out connection. Ensure that
the total current consumption of all connected devices does not exceed the specified value.
5. Replace plug-in power cables with original cables only.
DANGER:
1. Choking hazard! Plastic bags and small parts must be kept out of reach of persons (including
children) with reduced physical, sensory or mental capabilities.
2. Risk of falling! Make sure that the device is securely installed and cannot fall down. Only use suitable
stands or mounts (particularly for fixed installations). Ensure that accessories are properly installed and
secured. Ensure that all applicable safety regulations are observed.
WARNING:
1. Use the device in the prescribed manner only.
2. Operate the device using only accessories of the type recommended and supplied by the
manufacturer.
3. Observe safety regulations applicable in your country during installation.
4. After connecting the device, ensure that all cables are routed so as to avoid damage or accidents,
such as from tripping.
5. Be sure to observe the specified minimum distance to normally flammable materials! Unless explicitly
stated, the minimum distance is 0.3 m.
CAUTION:
1. Moving components such as mounting brackets pose a jamming hazard.
2. The housing surface of the device can become very hot during regular operation. Ensure that
accidental touching of the housing is not possible. Always allow the device to cool sufficiently before
removal, maintenance work and charging etc.
ATTENTION:
1. Do not install or use the device in the vicinity of radiators, accumulators, stoves, or other heat sources.
Ensure that the device is always installed in such a way that it is sufficiently cooled and cannot
overheat.
2. Do not place any ignition sources, such as burning candles, near the device.
3. Ventilation openings must not be covered and fans must not be blocked.
4. For transport, use the original packaging or packaging provided by the manufacturer.
5. Avoid any impacts to or shaking of the device.
6. Observe the IP rating and the ambient conditions such as temperature and humidity according to the
specifications.
EN
5