Palmer supreme soaker Bedienungsanleitung Seite 14

USER MANUAL
1 - 6 = level 1 (slight attenuation) to level 6 (strong attenuation).
FULL ATTN (with indicator LED) = maximum attenuation, SPK OUT loudspeaker output muted.
Overheating warning! If the warning symbol lights up red, the internal load resistors have overheated. Ensure
that the device is sufficiently ventilated and allow it to cool down before using it again!
Tip: Reduce the amplifier volume or feed more power to the external speaker (lower ATTN attenuation level).
14. LINE EQ
6-way switch for setting the sound characteristics for the LINE OUT line output (5 presets plus bypass).
15. AMP TO LINE OUT
PRE/POST
Switch not pressed (position PRE: The audio signal for the LINE OUT line output is tapped BEFORE the SPEAKER TONE
filter.
Switch pressed (position POST): The audio signal for the LINE OUT line output is tapped BEHIND the SPEAKER TONE filter.
TONE HARD/SOFT
Switch not pressed (position HARD).
Recommendation: Use this setting with a distorted guitar signal.
Switch pressed (position SOFT).
Recommendation: Use this setting with a "clean" guitar signal.
16. PHONES
Stereo headphone output with a 3.5 mm jack socket for the sum signal (LINE OUT plus AUX IN).
LEVEL
Volume control for the headphone output (turn to the left = quieter, turn to the right = louder).
CAUTION: The headphone output can produce high sound pressure levels (SPL) which can lead to
hearing damage. Avoid exposure to high volumes!
17. AUX IN
Stereo line input with a 3.5 mm jack socket. The line input may be used to connect a playback device such as an
MP3 player for play alongs, for example.
Note: The AUX IN line input signal is not output from the balanced LINE OUT line output.
LEVEL
Volume control for the AUX IN input channel (turn to the left = quieter, turn to the right = louder).
EN
14