Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Master/Slave Mode
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED IP PAD 60x3W CW/WW will respond to the controller.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
As soon as the digits blink, you can select the desired values via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
Controlling:
After having addressed the LED IP PAD 36x3W TCL, you may now start operating it via your lighting
controller.
DMX Channel Selection: Choosing a DMX Channel Mode up to 5 Channel Occupation
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode.
(2 CH, 5 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
DMX-Protocol
2-channel mode:
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
5-channel mode:
Channel:
Value:
1
000 – 255
Channel:
Value:
2
000 – 255
Channel:
Value:
3
000 – 255
Channel:
Value:
4
000 – 255
Function:
CW (0 – 100%)
Function:
WW (0 – 100%)
Function:
CW (0 – 100%)
Function:
WW (0 – 100%)
Function:
Dimmer (0 – 100%)
Function:
Strobe (0 – 100%)
30/32
00069276, Version 1.1
Werbung
Inhaltsverzeichnis
