Eurolite Led Ip Pad 36X3W Tcl, 51914162; Eurolite Led Ip Pad Cob Rgb 150W, 51914166 - EuroLite LED IP PAD Series Bedienungsanleitung

EUROLITE LED IP PAD 36x3W TCL, 51914162

EUROLITE LED IP PAD COB RGB 150W, 51914166

- STAND ALONE-MODE
• Solid colors/Internal programs
• Master/Slave Mode
- DMX MODE
- IR REMOTE CONTROL
STAND ALONE-MODE
Solid colors / Internal programs
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
the LED IP PAD 36x3W TCL and LED IP PAD COB RGB 150W, you can select up to 3 different chasers
plus solid colors.
Selecting a chaser
Press the MODE button to select the internal program mode. Select the desired chaser (01 – 04) via the UP
or DOWN buttons (see following graphic).
Press the ENTER button to select brightness of the solid colors, speed and flash settings, respectively. As
soon as the digits blink, you can select the desired values via the UP or DOWN buttons.
Speed from 00 to 99, increasing.
Flash from 00 to 99, increasing.
Please press the ENTER button to confirm and to exit this mode.
01.STATIC
02.CHANGE-7
03.CHANGE-3
04.DREAM-7
Master/Slave Mode
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
As soon as the digits blink, you can select the desired values via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
DMX Channel Selection: Choosing a DMX Channel Mode up to 6 Channel Occupation
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode.
(3 CH, 5 CH, 6 CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX Mode.
Please see the following DMX protocol graphics for the respective channel values.
R00 G00 B00 W00 F00
Seven color change
Three color change
Seven color fade
SP01-99 F00-99
SP01-99 F00-99
SP01-99 F00-99
27/32 00069276, Version 1.1