Master/Slave Mode; Dmx Mode - EuroLite LED FE-1000 Flowereffekt Bedienungsanleitung

Sound Control Setting
Press the MODE button until the display shows Addr.
Press the UP or DOWN button until the display shows Soud.
Press the ENTER button and select the desired microphone sensitivity (01 - 99) via the UP or DOWN
buttons. Press ENTER to confirm.

Master/Slave Mode

Choose the device which will serve as Master. Choose the Sound Control or the Auto Mode.
To set the Slave devices press the MODE button to choose Addr, then press the ENTER button to confirm.
Set the DMX start address 001 on every slave-device via the UP and DOWN buttons. Press the ENTER
button to confirm.
Display the software version
With the function VEr you can display the software version of the device
Press the MODE button until the display shows Addr.
Press the UP or DOWN button until the display shows VEr.
Press the Enter-button, the display shows the version number e.g. 1.0.00.

DMX Mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows Addr. Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons. Please press the ENTER button again to confirm.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller. Every DMX-
channel has a different occupation with different features.
If you set, for example, the address to channel 4, the device will use the channels 4 to 6 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED FE-1000
correctly and independently from any other fixture on the DMX-chain. If several LED FE-1000 are addressed
similarly, they will work synchronically.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash "A001" with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
21/24 00080254, Version 1.0