Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Glider user's manual | EONA 4
Opening the wing
Choose a flat or lightly angled training hill without obstacles or wind. Open your wing and arrange it in a
crescent shape. Check the fabric and the lines for any sign of wear or damage.
Check for the links connecting the lines to the risers to be fully closed.
Identify, separate and arrange the A,B.C, risers as well as the brake lines neatly. Knots or tangles can
not be present.
Choosing an adapted harness
The EONA 4 glider was certified EN-A with a EN1651 & LTF certified harness and hence can be flown with
most harnesses models found on the market today. Meaning that it can be flown with most harnesses
models found on the market today. We wil advise you to choose a EN1651 and or LTF certified harness
with a built-in dorsal protection system.
Connecting the wing to the harness
Without twisting the risers, connect them to the harness connection loops using the self-locking
carabiners. Check for the risers to be properly positioned and untwisted. The "A" risers must be located
at
the front and facing the flight direction( see schematic ). Lastly, check for the main self-locking carabiners
Harness chest strap spacing
It is advised to adjust the harness's chest strap width based on your wing
size :
40 cm for a EONA 4 size XS
42 cm for a EONA 4 size S
44 cm for a EONA 4 size M
46 cm for a EONA 4 size ML
48 cm for a EONA 4 size L
Installing the speedbar
Install the accelerator according to your harness manufacturer's
recommendations. Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected, adjust its length
according to your measurements. For correct use, there must
not be any tension at the split-hook level when the accelerator/
speedbar line is relaxed.
FR
EN
DE
Connecting the glider
Risers
Self-locking
Carabiners
Flight direction
Harness
SUPAIR
| EONA 4 | page 8
Werbung
