EuroLite LED IP PIX STROBE RGB/CW+WW Panel Bedienungsanleitung Seite 32

Master/slave operation
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
2 Select the desired setting at the master unit. The interconnected devices will now operate
synchronously.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 32 control channels.
However, it can also be switched to a mode with 6, 10, 18, 24 or 25 channels if different functions are
required. To be able to operate the device with a DMX controller, the DMX starting address must be set. The
starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1 Press the button MENU so many times until DMX Address is indicated on the display. Confirm with the
ENTER button. The display indicates the DMX starting address setting (001). Use the UP and DOWN
buttons to set the desired starting address and confirm with ENTER.
2 Press the button MENU so many times until Mode is indicated on the display. Confirm with the ENTER
button The menu for the DMX modes (DMX) is called up. Confirm with ENTER. Use the UP and DOWN
buttons to select the desired DMX channel mode: 6CH (6 DMX channels), 10CH (10 DMX channels),
18CH (18 DMX channels), 24CH (24 DMX channels), 25CH (25 DMX channels) or 32CH (32 DMX
channels).
3 Confirm with ENTER. When DMX signals are being received, a dot next to the DMX address on the
display will light up.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronously.
The LEDs of the device are divided into different segment groups, which can be controlled individually with
the following DMX protocol.
CW/WW Segment 1
RGB Segment 1
RGB Segment 2
CW/WW Segment 2
RGB Segment 3 RGB Segment 5
RGB Segment 4 RGB Segment 6
32/40
CW/WW Segment 3 CW/WW Segment 4
RGB Segment 7
RGB Segment 8
00150786, Version 1.0