Werbung
Verfügbare Sprachen
Verfügbare Sprachen
24 | English
Problem
The staples are driven in too deep.
The staples are not driven in deep
enough.
The power tool skips staples or has too
large a cycle feed.
Staples are frequently jamming in the
shot duct.
The driven staples are bent.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
1 609 92A 8UG | (22.11.2023)
Cause
The fasteners being used are not ap-
proved.
The magazine (13) is empty.
The fasteners have been pressed in the
wrong order.
The depth stop is set too deep.
The buffer is worn.
The battery is discharged or defective.
The fasteners are too long.
The depth stop is set too high.
The fasteners being used are not ap-
proved.
The spring of the magazine slider is too
weak or defective.
The fasteners being used are not ap-
proved.
The staples are old; the adhesive
between the staples has lost its retention
force.
The driver blade is damaged.
The power tool is being used on a mater-
ial that is not permitted (e.g. concrete,
stone).
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
Corrective measure
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Refill the magazine (see "Loading the
magazine (see figures A1–A3)",
page 20).
– Perform the discharging procedure
again, observing the correct order of
pressing when doing so.
– Change the actuation mode via the
user interface.
– Adjust the depth stop to the required
depth (see "Adjusting the depth stop
(see figure D)", page 22).
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Fully recharge the battery or replace
it.
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Adjust the depth stop to the required
depth (see "Adjusting the depth stop
(see figure D)", page 22).
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Use only original accessories. Only
the fasteners (nails, staples, etc.)
specified in the "Technical Data" table
may be used.
– Contact an authorised Bosch after-
sales service centre.
– Use a new staple strip
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Only use the power tool on permitted
materials. (see "Intended Use",
page 18)
Bosch Power Tools
Werbung
