Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance Schedule
– Clean the magazine (13). Remove plastic or wood shav-
ings that may accumulate in the magazine during work.
Measure
Cleaning the magazine (13) and
magazine slider (17).
Ensure that the discharge lock-off (2)
functions properly.
Rectifying Faults
Problem
The power tool is not ready for opera-
tion.
The power tool is ready for operation but
no staples are discharged.
Bosch Power Tools
Clean the power tool at regular intervals using com-
pressed air.
Explanation
Prevents a staple from becoming
jammed.
Promotes your work safety and efficient
use of the power tool.
Cause
The battery is discharged or defective.
The battery is not properly inserted.
The battery temperature is too high or
too low.
The battery contacts, motor or solenoid
are dirty or defective.
The magazine (13) is empty.
The discharge lock-off (2) is bent.
The electronic system is defective.
The user interface (9) is defective.
The following components may be faulty:
– Trigger (5)
– Driver blade
– Motor or drive belt
– Electronics
– Rubber bands
Foreign objects have accumulated in the
shot mechanism.
Foreign objects have accumulated in the
outlet (15) or in the magazine (13).
A staple is jammed in the shot duct.
The magazine slider (17) is defective.
The spring of the magazine slider is too
weak or defective.
English | 23
Action
– Blow out the mechanism of the
magazine/magazine slider daily with
compressed air.
– Blow out the mechanism of the dis-
charge lock-off daily with compressed
air.
Corrective measure
– Fully recharge the battery or replace
it.
– Make sure that the battery is firmly
engaged in the handle.
– Wait until the battery has reached the
optimal operating temperature again.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Refill the magazine (see "Loading the
magazine (see figures A1–A3)",
page 20).
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Contact an authorised Bosch after-
sales service centre.
– Contact an authorised Bosch after-
sales service centre.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
– Clean the outlet (15) or the
magazine (13).
– Clear the jam.
– Clean the magazine slider (17) as re-
quired and make sure that the
magazine (13) is not contaminated.
– Contact an authorised Bosch after-
sales service centre. Have the com-
ponent replaced there.
1 609 92A 8UG | (22.11.2023)
Werbung
