Master F-11 Bedienungsanleitung Seite 54

E03 Over current protection
1.Clean the dust between running board and belt,then put some oil
2.If the running belt wear seriously,please change the running belt
E04 Motor open circuit
1.Check the check the connect wire of motor,if the connect wire loose,please connect it again.
2.The motor carbon brush wear, replace carbon brush or motor
E05 EEPROM damage or access problems change the controller board
E06 Communication error
1.Check the connect wire between computer and controller board,if it loose or broken,please connect it
again or change it
2.change the nicline motor
E07 incline error when self-checking:
1.check the connect wire between incline motor and controller board if it get loose or broken,please connect
it again or change it
2.Change the incline motor
E08 speed error when self-checkin
1.check the distance from speed sensor to the magnetic of roller and adjust it within 3mm
2.Change the speed sensor
E09 short-circuit protection change the controller board
"－"safety key not connected
insert the safety key
Er when treadmill at running state,the treadmill at running state,the incline window display "Er"it is
incline VR error
1.check the connect wire between incline motor and controller board,if it get loose
it again or change it
2.change the incline motor
No Power
1. Check fuses (They are located on the controller under the motor cover )
2. Check power outlet (Plug something else into the power outlet to ensure that the power outlet is working
correctly).
3. Check Power Cable (You may need to take it to an electrician).
EN
or broken, pls connect
13