Parkside PKLL 8 A3 Originalbetriebsanleitung Seite 26

5. If additional height is necessary, loosen the locking screw
extend the centre column to desired height. Once reached the
desired height, tighten the locking screw
6. For a horizontal alignment of the tripod flat head
long handle
or down as desired. If the air bubble of the spirit level
exactly in the middle of the circle, the tripod flat head is aligned
horizontally. Then, tighten the long handle
7. If necessary, loosen the locking screw
head up to 360 degree horizontally to get desired side. Once
18
reached the desired side, tighten the locking screw
8. If necessary, loosen the locking screw
tripod flat head
Once reached the desired angle, tighten the locking screw
Securing the Cross Line Laser
Align -thread
the quick shoe and make sure to tighten the screw well by screwing
the metal key
9
the quick shoe
19
Removing quick shoe from tripod:
User can just remove the cross line laser together with quick shoe
from tripod by following below steps:
1. Pull the lever
2. Remove the quick shoe
3. If want to put back the cross line laser on the tripod again, pull the
lever on the tripod flat head
11a
back firmly on the tripod flat head
to bring back to original position and to firmly hold the quick shoe
(see fig. A).
19
4. Check the tight fitting of the quick shoe
head .
18
Maintenance and cleaning
The product requires no maintenance.
ATTENTION! Never submerge the product in water or other liquids.
Do not allow water to enter into the product during cleaning.
Keep the product clean to ensure good, secure work.
Use a dry cloth to clean the outside.
26 GB/IE
by turning anti-clockwise and move the handle up
12
up to 90 degree vertically to get desired angle.
18
of cross line laser with the
6
clockwise. The metal key
.
on the tripod flat head
11a
.
19
.
14
18
by turning it clockwise.
12
to rotate the tripod flat
13
to adjust the angle of the
10
-screw
is on the bottom side of
9
along the side.
18
and place the quick shoe
18
. Then, release the lever
18
within the tripod flat
19
and
14
, loosen the
is located
11
.
13
.
10
of
8
19
19
11a