Climadiff PRO161XDZ Gebrauchsanweisung Seite 37

Press for 3 seconds to unlock/lock all the functions.
Press left and
Press right and
Press left and
Press right and
Press to turn on or off the lights.
If no function is activated within 6 seconds, the touch screen will locked automatically.
Demo/eco mode
Eco demo mode can be activated by presenting the appliance at exhibitions or in salesrooms for
example. In eco demo mode, the compressor and all fan motors are switched OFF.
To activate this mode, press the "DOWN" button of left side on the control panel and lasts for 3 seconds
within the period of 10 seconds right after power is on. It means once the power is on you need to press
the button as soon as possible.
To finish the mode, you need to cut down the power. When the power is on again, the product will be in
normal cooling mode automatically.
5. EQUIPMENTS
The ventilation system: charcoal filter
Pure air continually changed and filtered!
Your Climadiff wine cooler is equipped with a continuous fresh air system, filtered by 2 charcoal filters. This
is a 5 cm diameter black plastic washer in the top left of the wine cooler at the back and at the middle of
your appliance. It should be replaced annually.
The anti-vibration system
The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is
insulated from the body by a thick layer of polyurethane foam. These characteristics prevent the
transmission of vibration to your wines.
Defrosting
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the appliance's
refrigerated surfaces are defrosted automatically. The defrost water is channeled into a condensates
evaporation tray which is located in the back of the appliance near the compressor. The heat produced by
the compressor then evaporates the condensates collected in the tray.
The winter system
The winter kit is a frost protection system which enables the wine cooler to operate in an environment
where the temperature is between 0 and 32°C. A sensor located inside the appliance triggers a low power
electrical element when the inner temperature of the wine cooler becomes inferior by 3°C than the set
temperature. This is a low power element to avoid sudden rises in the temperature of the wine and so
avoid thermal shocks that are damaging to the preservation of the wine. The kit is intended to raise the
wine cooler's internal temperature even before there is a thermal exchange with the bottles.
to adjust the temperature of the upper zone.
to adjust the temperature of the lower zone.
at the same time and hold for 3 seconds to power off.
at the same time for 3 seconds to switch from °C to ° F.
37