Sharp WC-S2000GM Serviceanleitung Seite 9

| VC-52000GM
4. ADJUSTMENT, REPLACEMENT AND ASSEMBLY OF MECHANICAL UNITS
The explanation given below relates to the on-site general service (field service) but it does not relates to the adjustment
and replacement which need high-grade equipment, jigs and skill. For example, the drum assembling, replacement and
adjustment service must be performed by the person who have finished the technical courses.
4-1 MECHANISM CONFIRMATION ADJUSTMENT JIG
So as to perform completely the mechanism adjustment prepare the following special jigs. So as to maintain the initial
performance of the machine the maintenance and check are necessary. Utmost care must be taken so that the tape is
not damaged. If adjustment needs any jig, be sure to use the required jig.
ream [rnin Pa] coon ne
This cassetie torque meter is used for check-
1. |Torque Cassette Meter JIGVHT-063 | CZ ; My ing and adjusting the torque of take-up for
' ; measuring tape back tension.
JiGTG1200 | CN
2. |Torque Gauge
These Jigs are used for checking
and adjusting the torque of take-up
and supply reel disks.
JiGTHOO06
Torque Driver JiGTD1200
Master Plane Jig and JiGRHO002
Reel Disk Height
Adjusting Jig
JiGMPO0001
JiGSG2000
Tension Gauge
This Jig is used with the tension
JiGSGO300
Pinch pressing force
gauge. Rotary transformer clearance
measuring jig
Torque Gauge Head AW
When fixing any part to the threaded
hole using resin with screw, use the
jig. (Specified torque 5 kg)
CB
These Jigs are used for checking
and adjusting the reel disk height.
There are two gauges used for the
tension measurements, 300 g and
2.0kg.
Reverse guide height This Jig is used for height adjustment of the
oes :
i
reverse
guide (for reverse
guide height ad-
adjusting box driver J@DAIVERTIOSS | AR | =) | fasten : .
Alignment Tape
VROUBZFS
—_——
VROCPSV
o| oon
X value adjustment ;
tment
Reverse Guide Height ; Tf This Jig is used for height
Adjusting Jig OE rhe uy P adjustment of the reverse guide.