Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VC-S2000GM
REEL
DISK
REPLACEMENT
AND
HEIGHT
4.iAssemble the Supply main brake ass'y.
=
-
Notes:
;
=
¢
Removal
1. When installing the reel disk, take due care so that-th
'I: "Remove the cassette housing control assembly.
_ tension band ass'y is not deformed and grease does no
2. Pull the tension band out of the tension arm ass'y.
adhere.
is reebdisk.
Note:
*« Reassembly (Take-up reel disk)
2. Align the phase of the reel disk to that of the reel relay
gear and to install a new take-up reel disk onto the shaft.
. Check the reel disk height and reassemble the take-up
main brake ass'y.
Note:
1. Take care so that the Take-up main brake ass'y is not
damaged. Take care so that grease does not adhere the
brake surface.
2. After reassembly, check the video search rewind back
tension (see page 15), and check the brake torque (see
page 17).
Supply main brake ass'y
¢
Height checking and adjustment
Note:
Take-up reel disk
1. Set the master plane with due care so that it does not
.
.
contact the drum.
2. When putting the master plane, shift the reverse guide
a little in the loading direction. Care must be taken since
excessive shift results in damage.
_" Supply reel disk
ae
£<e CBS
Figure 4-4.
Supply reel "SS
IES
Note:
Cassette lock
When the tension band ass'y is pressed in the direction of
keleaee ener
Position
the arrow for removal, the catch is hard to be deformed.
Takecup realidisk
ak
Figure 4-6.
Op
Oo
Note:
¢
Check that the reel disk is lower than part A but higher
Figure 4-5.
than part B. If the height is not correct, readjust the reel
¢
Reassembly (Supply reel disk)
disk height by changing the poly-slider washer under the
1. Clean the reel disk shaft and apply grease (SC-141) to
reel disk.
it.
2. Match the phases of reel disk and reel relay gear, and set
the new reel disk.
3. After checking the reel disk height, wind the tension
band ass'y around the reel disk, and insert into the hole
of tension arm ass'y.
12
Werbung
Inhaltsverzeichnis
