Trouble Shooting - norbar HANDTORQUE HT 1 Bedienungsanleitung

NOTE: Some of the ratios in the above table are a rough guide only, for more accurate results
please refer to the multiplication ratio on your Certificate of Calibration provided with your
HandTorque

TROUBLE SHOOTING

The following is only a guide, for more complex faults please contact your local Norbar agent or Norbar
directly.
Problem
Drive square sheared
Input drive rotates but output will not
Input drive will not rotate
(see page 8).
®
Likely Solutions
See maintenance section.
Serious damage to internal gears, return to Norbar or agent for
repair (Check AWUR change lever is not in neutral position).
Check AWUR change lever is in the correct position.
15