Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.9
Dimensions
Dimensions of the machine: (HxDxW):1580 x 600 x 840 mm
Weight 70 kg.
1.10 Equipment identification plate/type plate
Each spray gun cleaner has a type plate at the top right
of the machine with the following information:
Manufacturer's code.
-
Name and address of the manufacturer.
-
Model designation.
-
Serial number.
-
CE marking
-
The information on this plate must be given for all
service requests or orders of spare parts.
2. Installation
All of the following installation, adjustment and test procedures must be carried out
solely by qualified people. This guarantees that the work is carried out in accordance
with the safety regulations of the relevant directives.
2.1
Preparation
The HR 3000 is shipped in a shipping box marked "RISK OF BREAKAGE" and "DO NOT TILT" on the pallet.
The HR 3000 can be easily set up by 2 people using a means of transport.
Dimensions of the machine: (HxDxW):1580 x 600 x 840 mm – Weight 70 kg.
Packaging must be removed and disposed of in accordance with the locally valid waste regulations.
The machine must be connected by a qualified electrician with the attached earthing cable
-
(green/yellow) from the earthing screw to the corresponding earthing point of the building
(equipotential bonding rail) or to securely earthed metallic parts. The connection must be secured
so as not to become loose and it must not corrode.
Connect a possible steam extraction pipe to a suitable exhaust system with sufficient pipe
-
diameter, with the bend to the horizontal as close as possible to the spray gun cleaner.
Use Teflon tape to connect the hose to the compressed air inlet of the blow-out gun.
-
Warning! The maximum air pressure in the connection must be limited to 9 bar. If the air pressure
-
at the installation site is set to a higher pressure, a filter/regulator unit must be connected
upstream with a pressure gauge in order to set the air pressure to an operating pressure of 4 –
5 bar.
Place the supplied empty 20 l container to the right in the collection vessel at the bottom part of
-
the HR 3000. Now insert the 3 black flexible hoses into this container. This container is designed to
absorb dirty thinner. The thinner hose with the filter must always be inserted all the way down into
the container and must not have any bends or kinks.
Now place a full 20 l container of clean thinner to the left in the collection vessel of the bottom
-
part and insert the 2 grey flexible hoses and the 2 transparent hoses into the thinner in the
container. Ensure that the hoses are not bent or kinked and that all the hoses are in contact with
the bottom of the container.
Regularly clean the canister with the dirty solvent, otherwise the filters may quickly clog up due to
-
paint residues.
Make sure that thinner does not leak or contaminate the factory floor (overflowed thinner must be
-
removed immediately with an absorbent material).
Now close the bottom part of the spray gun cleaner with the cover panel.
-
Before using the machine, familiarise yourself with the HR 3000, the manual and how it works.
-
2.2
Adjustment options
Transferring clean thinner
-
Automatic cleaning of suction-cup guns (cup removed)
-
Automatic cleaning of gravity feed spray guns (mounted cup)
-
Automatic cleaning of gravity feed spray guns (no cup)
-
Manual post-cleaning
-
Semi-automatic post-cleaning in the cleaning tank
-
CE EX symbol II 2G EXh IIB T4 Gb
8
Werbung
