Werbung
Verfügbare Sprachen
Verfügbare Sprachen
with the paint inlet on the conical cleaning nozzle.
Then connect the air hoses to the side of the spray gun air inlet and clamp the cup upside down
-
on the holder in question.
Check again that the trigger of the spray gun is open and firmly locked with the clamp supplied.
-
Then close the lid of the cleaning tank and set the timer to ± 5 min.
-
Warning! The black lever must be in the horizontal position during automatic cleaning!!
After the automatic cleaning process has finished, the guns can be cleaned with clean thinner. To
-
do this, move the black lever to the vertical down position and press the red button for 5 seconds.
Then return the lever to the horizontal position. The paint spray guns are now cleaned inside and
-
out with clean thinner.
3.3.3
Automatic cleaning of gravity feed guns (cup mounted)
Remove the lid of the cup. Pour the rest of the paint from the cup into an extra container.
-
Pull back the trigger of the gun and lock it in place with the hook provided.
-
Then connect the clear air hose with the conical connector to the air inlet of the spray gun.
-
Place the gun with the cup upside down in the relevant clamp holder.
-
Check again that the trigger of the spray gun is open and firmly locked.
-
Clamp the inside of the cover onto the cover holder.
-
Then close the door and switch on the diaphragm pump. Set the timer to ± 5 min.
-
Warning! The black lever must be in the horizontal position during automatic cleaning!!
After the automatic cleaning process has finished, the guns can be cleaned with clean thinner. To
-
do this, move the black lever to the vertical down position and press the red button for 5 seconds.
Then return the lever to the horizontal position. The paint spray guns are now cleaned inside and
-
out with clean thinner.
3.3.4
Automatic cleaning of gravity feed guns (without cup)
[Recommended!]
Pour the rest of the paint into an extra container.
-
Remove the cup from the gun.
-
Pull back the trigger of the gun and lock it in place with the hook provided.
-
Then place the gun with the paint inlet on the conical cleaning nozzle.
-
Then insert the clear air hose with the conical connection into the air inlet of the spray gun and
-
clamp the cup upside down on the holder in question.
Double-check that the trigger of the spray gun is open and firmly locked with the clamp provided.
-
Set the timer to ± 5 min.
Warning! The black lever must be in the horizontal position during automatic cleaning!!
After the automatic cleaning process has finished, the guns can be cleaned with clean thinner. To
-
do this, move the black lever to the vertical down position and press the black button for
5 seconds.
Then return the lever to the horizontal position. The paint spray guns are now cleaned inside and
-
out with clean thinner.
You can clean 2 paint spray guns at the same time. In addition, other parts can be manually pre-
cleaned or rinsed with clean thinner during the automatic cleaning time. If the paint spray gun to
be cleaned has not been completely cleaned, the cleaning time can be extended using the timer or
it can be cleaned manually. There are two options for this on the upper inner part of the machine.
They can be switched on manually.
3.3.5
Manual post-cleaning
Remove the individual parts from the cleaning tank and place them on the grate.
-
Clean the individual parts with clean cleaning thinner, switched on using the lever in the downward
-
vertical position.
Clean the individual parts with the spray atomiser by switching on the lever in the downward
-
12
Werbung
