Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN 1149-1, 2, 3 and EN 13034 certified anti-static clothing
-
EN 405 certified filter mask A2
-
Anti-static safety shoes (minimum S1)
-
1.3
Place of use
The HR 3000 must be installed on a flat, absolutely level surface.
The space (location) must be well ventilated in accordance with hazard classification EN 60079-1-2016.
It is recommended that the unit be connected to an extraction duct with a separate, approved fan or
mechanical forced ventilation with an extraction volume of 700 m³/sec. so that, for example:
Zone 1 at a distance of up to 0.5 m around the machine
-
Zone 2 from a distance of 1.5 m around the machine are covered in accordance with the local
-
regulations
1.4
Intended use
The HR 3000 RVS is approved for automatic and/or manual cleaning of spray guns only. Cleaning of spray
guns and their accessories with buildup of conventional paint systems is carried out exclusively with
solvent-based cleaning fluids (cellulose thinners) or specified cleaning fluids from gas groups IIA & IIB.
1.5
Disclaimer
EMM rejects all claims and their consequences arising from negligence or non-observance of these
operating instructions.
1.6
Transport
The HR 3000 is shipped in a shipping box marked "RISK OF BREAKAGE" and "DO NOT TILT" on the pallet.
The HR 3000 can be easily set up by 2 people with a means of transport/forklift truck.
1.7
Copyright
The right to change the contents of this manual may be performed solely by the author in accordance with
Section 39 of the German Copyright Act (UrhG).
1.8
Product overview
The HR 3000 is an innovative, fully pneumatic washer. The HR 3000 is made entirely of stainless
-
steel and has hoses for transferring the solvent and powder-coated instrument levers on the front
of the control panel.
The HR 3000 is equipped with a diaphragm pump.
-
The machine uses a Venturi principle for manual cleaning. Clean cleaning fluid is sucked in from a
-
container (not included in the package delivered) in the lower part of the machine.
The used, soiled cleaning fluid is then drained via the cleaning tank into a second container (empty
-
recipient with filling opening in accordance with DIN 61, included in the package delivered).
Harmful gases and vapours that can form in the upper and lower part of the HR 3000 must be
-
extracted by a mechanical forced suction with an extraction volume of 700 m³/h.
The lid of the cleaning tank must always be closed during the automatic washing process. A safety
-
valve immediately stops the feed pump if the lid of the cleaning tank is not closed or is being
opened.
The following can be operated from the control panel on the front:
-
- Activating the supply to the atomiser
- Activating the supply from the clean thinner
- Activating/deactivating automatic washing process
- Setting the timer for the cleaning process
- After the washing process has finished, switching on the final manual cleaning
- Pumping up clean solvent
- EMERGENCY STOP
7
Werbung
