Abus RWM250 Bedienungsanleitung Seite 16

Assembly
In the event of a fire, this device quickly detects the build-up of smoke and
also the associated rise in temperature in the room. In order to warn you in
good time, it then emits a loud alarm sound. If you decide that there is no
real need to escape the building you can temporarily deactivate this signal
(for approx. 10 minutes), or temporarily disable it before sounding,
by gently pressing the Test/Stop button (Fig. 1, IV). We recommend that you
then provide good ventilation to the room to prevent the alarm being
triggered again.
Assembly
The smoke alarm is held in place by a magnetic holder attached to the
mounting site. Please note that the magnetic holder only has a strong
magnetically attractive force from one direction. The magnetic holder
may either be mounted by an adhesive fixing or by drilled holes:
1. Adhesive mounting
1.1 Adhesive mounting with fasteners magnetic holder, self-adhesive
coated in accordance with EN14604:2005/AC:2008
Warning: The sole use of this selfadhesive fastener produces a very mainte-
nance-friendly, stable and magnetic connection of the device to the
installation site
The device can be detached from the magnetic holder by gently pulling it
downwards e.g. for inspection, maintenance or cleaning
For this adhesive mounting, only the supplied adhesive may be used.
The assembly site must be
• firm
• dry
• free of dust, grease or loose paint, etc.
– 30 –
Application:
a) Remove the information sticker and the protective film from the applied
adhesive material (Fig. 3) on the magnetic holder.
b) Press the adhesive surface of the magnetic holder firmly
onto the mounting surface for approx. 10 seconds.
c) Place the device on the magnetic holder.
d) The adhesive bond will reach its ultimate strength
after approx. 72 hours.
e) If required, the device can be removed from the
magnetic holder by pulling it gently in a vertical motion.
1.2 Adhesive mounting with optional fixing device in addition to 1.1
(thin double-sided adhesive film) in accordance with vfdb (German
Fire Protection Association) 14/01 (Q) and EN14604:2005/AC:2008
Warning: The additional use of this optional adhesive produces an
extremely stable and long-lasting connection between the device and the
fixture and thus with the mounting base.
The device can no longer be removed by pulling it from the magnetic
holder (this means significantly greater security against unautho rised removal,
theft etc.)
Only use this method of fixing when you are absolutely certain that the
device must remain permanently fixed and that it should not be removed.
Be certain to note that this is a very strong fixing; the unit can only be
removed with great effort and possible damage to the mounting site and to
the device. We accept no liability for any damage incurred !
For this adhesive mounting, only the supplied adhesive may be used.
The assembly site must be
• firm
• dry
• free of dust, grease or loose paint, etc.
Fig. 3
– 31 –
Assembly
GB