Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GLUE mode:
On the SETTINGS screen below, the user can specify the presence glue between the panels/sheets. When this mode is in use, a pre-spot is performed
before the weld. The duration of this pre-spot is set in milliseconds, from 0 to 400 ms, with 50 ms thresholds. When the glue mode is selected, la
word « GLUE » is displayed in the menus of the NORMAL, MANUAL, MULTI or GYSTEEL welding modes.
USE OF THE GUN (OPTION)
- Select the GUN tool using the button
Attach the gun grounding cable to the mobile electrode. Slide and tighten the knurl.
Connect the control cable to the jack plug.
Check that the screw connecting the shoe to the cable lug is tight.
- Fix the earth pad firmly and as close to the weld as possible.
In the case of a monopoint weld, always place the earth on the sheet/panel that is not in contact with the welding electrode (in order for the current
to go through the two sheets to be welded).
- Weld starting with the furthest spot away from the earth and work towards it.
- The normal welding mode using the stars is the one used by default.
- The gun can be used in normal or manual mode.
IMS SPOT 14500 TRAFO PRO
daN control :
This setting allows you to activate or control the clamping force of the clamp during a weld.
.
Remove the arm from the clamp and fix, in its place, the gun cable.
EN
39
Werbung
