Herunterladen Diese Seite drucken

Pioneer PD-S602 Bedienungsanleitung Seite 6

Werbung

CONTENTS
ABOUT THESE OPERATING INSTRUCTIONS... 6
CAUTIONS REGARDING HANDLING
CONNECTIONS ou... eeeeeeeeseceeseeceecenecestacee
CONFIRM SUPPLIED ACCESSORIES ..............:esceseeeeees 14
PUT BATTERIES INTO THE REMOTE
CONTROL UNIT
14
ABOUT THESE OPERATING INSTRUCTIONS
The contents found in these Operating Instructions are based on the
PD-S602 model, but they are also applicable to the PD-S502 model.
AC power cord connection and functions
Some functions cannot be carried out depending on the connection
of AC power cord.
When the AC power
cord is connected to
the
unswitched | theswitched outletof
outletofanamplifier | an amplifier or audio
or wall outlet.
timer.
ee
ee
Output level memory | Yes
No (PD-S502)
Yes (PD-S602)
WhentheAC power
cordis connected to
CAUTIONS REGARDING HANDLING
Install the player in a well ventilated location where it will not
be exposed to high temperature or humidity.
Do not install the player in a location which is exposed to direct
rays of the sun, or near stoves or radiators. Excessive heat can
adversely affect the cabinet and internal components.
Also,
installation of the player in a damp or dusty environment may
result in malfunction or accident.
Precautions regarding installation
Avoid placing the player on heat-generating sources such as
amplifiers.
Install this compact disc player as far as possible from tuners
and TV sets.
Noise may be particularly noticeable when an
indoor antenna is used. In such a case, make use of an outdoor
antenna, or turn off power to the compact disc player.
Please place this unit on a level surface.
oO
<PRE1173>
En
Cleaning the player
To clean the PLAYER, wipe with a soft, dry cloth. For stubborn
dirt, wet a soft cloth with a mild detergent solution made by diluting
one part detergent to 5 or 6 parts water, wring well, then wipe off
the dirt. Use -a dry cloth to wipe the surface dry. Do not use
volatile liquids such as benzene and thinner which are harmful to
the unit.
Storing discs
Be careful not to allow discs to warp; always store discs in their cases
vertically, avoiding locations with high heat or humidity, or extremely
low temperatures.
CD lens cleaner
The player's pickup lens should not become dirty in normal use,
but if for some reason it should malfunction due to soiling, consult
your nearest PIONEER authorized service center.
Lens cleaners
for CD players are commercially available, but special care should
be exercised in their use since some may cause damage to the
lens.
Condensation
When this unit is brought into a warm room from previously cold
surroundings
or when
the room
temperature
rises sharply,
condensation may form inside, and the unit may not be able to
attain its full performance. In cases like this, allow the unit to stand
for about an hour or raise the room temperature gradually.
Cleaning and handling compact discs
Always keep your discs clean by wiping them gently with a soft
cloth from the inner edge toward the outer periphery.
If a disc becomes very dirty, dip a soft cloth in water, and after
wringing it out well, wipe the dirt away gently, and then remove
any water drops with another soft, dry cloth.
Do not use record cleaning sprays or anti-static agents on discs.
Also, never clean discs with benzene, thinner, or other volatile
solvents, since damage to the disc surface may result.
With this player, use discs which display the mark shown below.
(Optical audio digital discs.)
When holding discs, do not touch their signal surfaces (the side
reflecting a "rainbow" pattern, opposite the label side). Hold by
the edges, or by one edge and the center hole.
Do not affix gummed labels or tape to the label surfaces. Also,
do not scratch or damage the label.
;
Discs rotate at high speed inside the player. Do not use damaged
(cracked or warped) discs.
NOTES:
@
When setting an 8 cm CD single, do not use the 8 cm CD
single adaptor.
@
Never attempt to load both 8 cm and 12 cm discs together,
since disc damage or other malfunctions may result.
Always
load only one disc at a time.

Werbung

loading

Diese Anleitung auch für:

Pd-s502