Werbung
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check
the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being
used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your
dealer to carry out repair work.
co
Disc tray is not expelled when OPEN/ | @ Power plug is disconnected from outlet.
@ Connect plug to amplifier or wall outlet.
CLOSE is pressed.
@ The POWER switch is OFF (STANDBY).
e Press the POWER switch ON.
When Playback is started, it stops | e
Disc is loaded upside down.
@
Load the disc with the label side DOWN.
immediately. Pauses or stops during | e Smudges, etc., on the disc.
e
Clean the smudges from the disc and then play
playback.
it again.
Output cables are connected incorrectly or | @
Connect properly.
loosely.
Incorrect operation of stereo amplifier.
@
Check the settings of amplifier switches and
sound volume conirols.
' Pin plugs and/or amplifier terminals are dirty. | @
Clean away dirt.
Player is in pause mode.
e
Press the PLAY > button.
Sound is distorted, noise is output.
Incorrect connections.
e@ Connect to amplifier's AUX or CD terminals.
Do not connect to PHONO terminals.
Pin plugs and/or amplifier terminals are dirty. | @
Cleanawaydirt.
.
Interference is being picked up from a TV | @
Switch OFF TV set, or move player away from
set.
TV set.
With certain discs, loud noise is | @ Disc has bad scratch or warp.
@ Replace the disc.
produced, or play stops.
e
Disc is extremely dirty.
e@ Clean disc.
The picture of the TV screen is | @ Interference is being picked up from the | e Turn off POWER of the player, or move the
hard or FM broadcast has noise
CD player.
player away from TV or tuner.
interference.
Abnormal functioning of this unit may be caused by lightning, static
electricity, or other external interference.
To restore normal
operation, turn the power off and then on again, or unplug the AC
power cord and then plug it in again.
40
<PRE1173>
En
Werbung
