Interlogix SB Serie Installationshandbuch Seite 32

Specifications
Detector model
Maximum protected
distance for interior use
Maximum protected
distance for outdoor use
with thermostat controlled
heating
Type of detection
Number of cells
Detection mode
Intrusion alarm response
time
Disqualification alarm
response time
Typical duration of intrusion
alarm
Power supply
Current consumption at
12 VDC (1 module)
Heater power supply
Heater current consumption
at 12 VDC (1 module)
Intrusion output for each
switch NC alarm off
Tamper output for each
switch NC alarm off
Disqualification output for
each switch NO alarm off
Intrusion alarm output
rating
Tamper output rating
Disqualification alarm
output rating
Operating temperature with
thermostat controlled
heating
Protection rating
Weight
Cell direction adjustability
32
SB250-N SB2100-N
125 m 250 m
50 m 100 m
Pulsed infrared beam of wavelength 950 nm at a choice of
1 cell
Cell beam is interrupted
Adjustable from 50 to 800 ms
60 s, non-adjustable
Duration of cell beam interruption, with a minimum of 4 seconds
47 mA 47 mA
80 mA 80 mA
Yes (cutting the intrusion alarm)
0,8 kg 0,9 kg
SB450-N SB4100-N
125 m 250 m
50 m 100 m
4 channels
2 cells
1 or 2 cell beams are
interrupted. See "Single
module alignment and
settings" on page 15 for
more details.
10 to 15 VDC
55 mA 55 mA
10 to 15 V AC/DC
160 mA 160 mA
Yes
Yes
30 VDC, 500 mA
30 VDC, 500 mA
30 VDC, 500 mA
−25 to +55°C
IP44
1,1 kg 1,2 kg
Vertically ±10°
SB Series AIR Beam Detectors Installation Manual
SB4200-N
350 m
200 m [1]
Both cell
beams are
interrupted
55 mA
160 mA
1,2 kg