Werbung
Verfügbare Sprachen
Verfügbare Sprachen
stronger; e.g. with twice the value in case of pressures of 20 bar, with three times the value in case of
inlet pressures of 30 bar, etc.
∙
Check the leak tightness of the line connections at the pump inlet and outlet and the shaft sealing on a
regular basis. Check leak tightness of the heating connections of pumps with liquid heating on a regu
lar basis.
∙
If the leakage at the shaft sealing is too high or stuffing box packings cannot be further tightened
(please, observe safety instructions in section 1.9), the packings (e.g. packing rings, gaskets) must be
replaced as specified in the spare part catalog (may be ordered from Barmag).
The pump shaft must be checked for damage in the sealed part and replaced if necessary.
5.2
Spare Parts
The following information is required when ordering spare parts:
∙
Barmag pump No. (engraved on the pump)
∙
Exact identification of the parts as listed in the spare‐parts catalog (can be ordered from Barmag)
∙
Quantity
∙
Barmag item No. (engraved in the pump)
Contact:
Pump Sales Dept.: Tel. 0049 2191 / 67‐1235 Fax: 67‐3364
Pump Service Dept.: Tel. 0049 2191 / 67‐2815 Fax: 67-702815
6.
Faults
Any faults can be remedied by the Barmag Pump Service or the operating party's own trained personnel.
In addition, the pump can be sent to Barmag's Pump Service with a damage identification note serving as
repair order.
7.
Pump Data Sheet
The pump‐data sheet is supplied together with the Operating Instructions.
Page
22
Customer:
Order:
Edition:
01.20
Werbung
