Kopp Free-control Bedienungsanleitung Seite 80

All manuals and user guides at all-guides.com
GB
Programming procedure – wireless adapter
1. Connect the wireless adapter to power
(e.g. plug into a safety outlet).
2. Press the PROG. button 7 of the wireless
adapter with the included programming
stylus and hold down approximately
2 seconds until the internal LED 5 (red)
lights up.
3. The programming mode is now activated
for 20 seconds.
4. Then, press the PROG button 8 of the
wireless magnetic sensor > 2 seconds.
5. The LED 2 of the wireless magnetic
sensor blinks briefly.
6. The wireless magnetic sensor sends two
signals: first the OFF signal, then the ON
signal within 2 seconds
7. The LED 5 of the wireless adapter must
blink 2x.
8. The system automatically exits the
programming mode.
80
7
5
Delete programmed linking
1. Press the PROG. button 7 of the wireless
adapter or 1-channel/3-wire wireless
receiver with the included programming
stylus and hold down approximately
10 seconds.
2. The LED 5 . lights up after approximately
3 seconds.
3. After another 7 seconds, the LED 5
blinks 2x and then goes off.
4. Finished – all programmed links are now
deleted. Ready to program new devices.
Note: Only the entire memory can be
deleted. It is not possible to delete certain,
individual transmitters.