Parkside PABH 20-Li C3 Originalbetriebsanleitung Seite 12

Changing a tool
■ You can use the SDS-plus tool holder
change tools quickly and easily without the
need for any additional tools.
■ The SDS-plus drilling tool moves freely
(depending on the system). This leads to a
radial run-out deviation while idling. This has no
effect on the accuracy of the drill hole as the
drill centres itself during drilling.
■ The dust protection cap
entry of drilling dust into the tool holder
during operation. Ensure that the dust protection
cap does not get damaged when fitting
tools.
NOTE
► A damaged dust protection cap
replaced immediately. We recommend
having this done by a customer service
workshop.
Fitting an SDS tool/quick-release
chuck
WARNING!
Do not use the quick-release chuck
►
for hammer drilling or chiselling!
♦ Before fitting a tool into the tool holder
grease it lightly.
♦ Twist the tool into the tool holder
audibly into place.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing an SDS tool
♦ Pull the locking sleeve
remove the tool.
│ GB │ IE
■ 8
to
largely prevents the
must be
,
until it clicks
backwards and
Operation
Select operating mode
■ Use the "Drill/hammer drill" switch
select the operating mode of the power tool.
NOTE
► Change the mode only when power tool is
switched off! Otherwise, the tool could be
damaged.
♦ To change the operating mode, turn the "Drill/
hammer drill" switch
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF
Setting the rotation direction
NOTE
► Operate the rotation direction switch
when the appliance is at a standstill.
■ You can use the rotation direction switch
to change the direction of rotation of the power
tool. This is not possible, however, while the
On/Off switch is pressed in.
Clockwise
♦ For drilling and screwing in screws, turn the
rotation direction switch
as the stop.
Anticlockwise
♦ For undoing and removing screws and nuts,
turn the rotation direction switch
as far as the stop.
Switching on/off
Switching on
♦ To start the power tool, press the On/Off
switch and keep it pressed in.
■ The LED work light
Off switch is pushed in slightly or fully and
illuminates the working area in low light condi-
tions.
to
to the desired position.
only
to the left as far
to the right
lights up when the On/
PABH 20-Li C3