Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dust extraction
WARNING! RISK OF FIRE!
►
When working with power tools that have a
dust collection box or can be connected to
a vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e .g . when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite .
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time . Therefore, do
not allow the workpiece to overheat and
always empty the dust box or the dust bag
of the vacuum cleaner before taking a break
from work .
Wear a dust mask!
NOTE
►
Perforated sanding sheets are required for
dust extraction .
Dust box
Connecting:
♦
Push the dust box
far as the stop .
Removal:
♦
Press the release button
and pull it off towards the rear .
NOTE
►
To achieve optimum dust extraction, the dust
box
should be emptied regularly .
♦
To do this, remove the dust box
appliance as described above . Open the dust
box by pulling on the tab
the lid . Clean both parts thoroughly by tapping
them out .
PMFS 200 C3
onto the multi-sander as
of the dust box
from the
and then removing
Reducer
Connecting:
♦
Push the reducer
♦
Push the hose of a suitable of vacuum cleaning
appliance (e .g . a workshop vacuum cleaner)
onto the reducer
Removal:
♦
Pull the hose of the vacuum cleaner off the
reducer
.
♦
Remove the reducer
Use
CAUTION!
►
Ensure that the appliance is switched off
before connecting it to the mains .
NOTE
►
Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece .
Switching on and off
Switching the appliance on:
♦
Move the ON/OFF switch
Switching the appliance off:
♦
Move the ON/OFF switch
Setting the oscillating speed
You can set the desired oscillating speed using the
speed selector
as required . The required speed
depends on the material being processed and can
be determined through practical tests .
Working procedures
■
Switch the appliance on before applying it to
the workpiece .
■
Apply minimal pressure when working .
■
Work at a constant speed .
■
Change the sanding sheets regularly .
into the adapter fitting
.
.
to the "I" position .
to the "0" position .
GB │ IE │ NI │ CY
│
.
7
■
Werbung
