Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In the easy steam cleaning func-
tion, it is expected that the added
water evaporates and condenses
on the inside of the oven and the
oven door in order to soften the
light dirt formed in your oven. Con-
densation formed on the oven door
may drip around when the oven
door is opened. As soon as you
open the oven door, wipe off the
condensation.
(It varies depending on the product model.
It may not be available on your product.)
After the condensation inside the oven,
puddle or moisture may occur in the pool
channel under the oven. Wipe this pool
channel with a damp cloth after use and
dry it.
7.6 High temperature self-cleaning
The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature
of approximately 420-480 °C and burns
until the existing dirt turns to ash. A strong
smoke may be generated. Provide good
ventilation. High-temperature cleaning
should be performed after approximately
every 10 uses of the oven.
General warnings
Hot surfaces cause burns!
Do not touch the product during
self-cleaning and keep children
away from the product. Wait at
least 30 minutes before removing
the residue.
• Before using the pyrolysis function, re-
move all accessories, the telescopic
shelf and the side shelves (if any). If not
removed, the accessories and side wire
shelves will be damaged.
• If your product has a pyro proof access-
ory (resistant to high temperature self-
cleaning), you do not need to remove
these accessories from the oven.
Whether your accessories are pyro-proof
or not is specified in the accessories
section. If not specified, your accessor-
ies are not resistant to high temperat-
ures. It must be removed from the oven
before cleaning to avoid damage.
• Do not clean the door seal. The glass
fiber seal is very delicate and easily
damaged. If the door seal is damaged,
replace it with a new one from an au-
thorized service.
To start the pyrolysis function:
1. Remove all accessories inside the oven.
In the models with wire shelves, re-
member to remove the wire shelf.
2. Before starting the cleaning, clean the
outer surfaces of the oven and the food
residues inside the oven with soapy
cloth.
3. Select the "Pyrolysis" or "Pyrolysis -
economy mode" function according to
the dirtiness condition of your oven. If
your oven is not very dirty, we recom-
mend using the "Pyrolysis - economy
mode" function. This function takes
less time than the "Pyrolysis" function.
If the oven is very dirty, the "Pyrolysis -
economy mode" function may not be
sufficient. In this case, clean it by the
"Pyrolysis" function.
4. Start cleaning by touching the
ð Cleaning starts and the self-clean-
ing time appears on the display.
This time is unchangeable.
EN / 38
key.
Werbung
