Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ð When the oven switches to the
setup mode, an animation is
shown on the display where some
lines flash.
2. Open the "HomeWhiz" application you
have installed on your smart device.
After creating your home, select the
oven under kitchen appliances and
enter the stock number of your product
to the application and follow the steps
described on the application.
The stock number of your product
is the number starting with "77..."
located at the bottom of the front
cover of the manual.
3. Complete the introduction of your oven
to the application by following the in-
structions provided on the application.
Activating the remote control of the oven
After introducing your oven to the "Home-
Whiz" application, to allow remote control:
1. Touch the
key once while the
symbol is shown on the display.
ð On the display, the
displayed with the
gether.
If the
symbol is not displayed,
touch the
bol is shown on the display. If you
have not introduced your appliance
to the HomeWhiz application, the
symbol flashes once and an er-
ror signal is heard.
Compliance with the standards and testing information / EU declaration of conformity
symbol shall be
symbol to-
key until the
sym-
If the
display, but an error signal is heard
when the
the
the display or the
blinking, check the internet con-
nection of your product. If the in-
ternet connection is OK and the
problem persists, repeat the steps
for installation.
Removing the pairing of an oven connec-
ted to "HomeWhiz"
After adding your product to the "Home-
Whiz" application, the user account you
used for "HomeWhiz" pairs the information
of your product. In order to delete a pair
due to loss of access to the account you
use in the application or for other reasons,
the following actions must be taken.
1. With the product turned off (while the
time of day appears on the display),
touch the
ately 5 seconds.
ð A countdown from 5 appears on
the display.
2. After the countdown is complete, a de-
leting pair animation will appear on the
display.
3. After the deleting pair process is com-
pleted without any problem, a warning
sound will be heard and your oven will
restart.
If a problem is encountered in the
process of deleting a pair and the
process cannot be completed, an
error sound will be heard.
4. You can re-pair the product to your
"HomeWhiz" account after deleting pair
process is completed.
EN / 28
symbol is shown on the
key is pressed and if
symbol is not displayed on
symbol is
and
keys for approxim-
Werbung
