Haier HUC44GDEH1 Benutzerhandbuch Seite 21

EN
3) Disassembling the Door Panel
Place the door with the door panel facing up on a platform (avoid bumping it).Use a
flathead screwdriver to carefully pry off the right-side upper and lower panels marked "③"
and "④", as well as the left-side upper and lower panels marked "⑤", at the positions
shown in the diagram. Be careful not to damage the door seal while removing the panels.
5
Note: After removing the panels, please store them safely for future use.
4) Swapping Upper and Lower Hinges:
Use a wrench to remove the screws that secure the hinges in place. Remove both the
upper and lower hinges (the method for disassembling the upper and lower hinges is
the same).
Move the upper and lower hinges to the diagonal positions, as shown in the diagram
below. Finally, use a wrench to securely fasten the hinge screws in place.
upper
lower
5) Installing the Door Panel:
Install the upper and lower hinge cover panels "⑤,"
the right-side upper and lower hinge cover panels
"⑥" and "⑦" (found in the accessory bag
) onto their corresponding positions on the
door.
Ensure that they are properly installed and not
loose.
5
Installation
3
4
upper
lower
6
5
5
7
19