Haier HUC44GDEH1 Benutzerhandbuch Seite 20

Installation
The following illustration demonstrates the connection and fixation of the left-side
bracket to the cabinet. The method for the right side is the same.
Fasten screws at
the top of the
upper cabinet
9. Switching Door from Right to Left
This product is designed with right-side hinges. If you need to change it to left-side open-
ing, please follow the steps below.
For hinge replacement, please contact our after-sales professionals for assistance.
1) Disassembling the Cabinet Cover Panels
Remove the non-hinge side cover panel: Open the door and use a flathead screw-
driver to pry off the panels marked with "①" at the positions shown in the diagram.
Remove the hinge side cover panel: Open the door, press one end of the cover panel
with your fingers (press the curved end when removing "②"), and use a flathead
screwdriver to pry the other end of the panel off at the positions shown in the diagram
marked with "②".
1
Note: After removing the cover panels, please store them safely for future use.
2) Disassembling the Door
Have one person hold the door with both hands. Have another person remove the upper
and lower hinge securing screws. Then, carefully disassemble the door, including the
upper and lower hinges and the cable chain wire box, by lifting it off.
18
I-shaped bracket
1
screws
Fasten screws
to the cabinet
side panels
or
T-shaped bracket
hinge
2
2
EN