Haier HUC44GDEH1 Benutzerhandbuch Seite 18

Installation
After selecting the appropriate recess space, please follow the steps below for the
embedded installation.
4. Tools required
1) Tools required
I-shaped bracket*2
T-shaped bracket*2
Note: The kickboard should be placed inside the packaging top cover foam, while the other
components should be placed in the accessory bag.
2) Kickboard Pre-Assembly
Take out the kickboard with 2 small connectors, and 2 screws-C. And then, use screws-C
to assemble the kickboard and small connectors together.
tiny
connectors
10mm
Note: Do not tighten the screws. Leave a 10mm as gap between the small connectors and the
kickboard to facilitate future installation into the machine compartment.
5. Installing Fixed Brackets
Each wine cellar provides two types of fixed brackets, which can be selected based on
your furniture arrangement at home.
Take out the appropriate 2 brackets and 4 screws-A, and install them as shown in the
diagram below:
Use a flathead screwdriver to remove
the top two small cover plates.
6. Adjusting the Bottom Feet
Adjust the height of the four Bottom Feet at the bottom of
the cabinet so that the distance from the bottom of the
door to the ground (h) matches the height of the cabinet's
kickboard.
→
→
16
kickboard*1
tiny connectors*2
Secure the T-shaped bracket using
a Phillips head screwdriver.
raise
Rotate clockwise to raise the cabinet height.
Rotate counterclockwise to lower the cabinet height.
screws-A*4
screws-C*2
kickboard
lower
screws-B*4
or
Secure the I-shaped bracket using
a Phillips head screwdriver
Adjustable Bottom Feet
EN
h