Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Starting locomotive operation
Operating instructions: Beforeuseis advisable
to let the loco go aroundabout30 minutesfor-
wards and 30 minutes backwards without load, to
obtain an optimal circuit and best tractive power.
The smallest radius this model should run is R2 of
the ROCO tracksystem (R2= 288,2mm).
Yourlocomotive will runsmoothly on cleantracks
only.Forthis purpose we recommend usingitem
no.25093, Roco track cleaning van, or item no.
10002, Rocotrack cleaning rubber, for remo-
ving heavydirt.
Installation
for the close-coupling: For the
installation of the close-coupling the following
two articles of the Fleischmann*-production-pro-
grammwill beneeded: i temno.9572 (the adap-
ter) and item no. 9570 (the coupling-device,
adjustablefor height) (see fig. I). Beforethe
installationpleaseremovethe body of the loco
(seefig. 2).
4
Collection
of current:
constructed for both,overhead currentpickupand
currentpickupfrom the tracks(please seefig. 3).
If this loco will be used on a layout with intact
overheadcables(no matter if with overheadcur-
rentpickupor currentpickupfromthe tracks)the
switch mustbe seteitheron purecurrentpickup
or on purecurrentpickupfromthetracksasother-
wise - under use of a least two locos with exten-
and a switch-position as
ded pantographs
shownin fig. 3 therewill bea risk of a short-cir-
cuit.Priorto thisremovelocobody(fig.2).
Multiple train-running; Fig.3: Forthe installati-
on of the decoderpleasecontacta ROCO-dealer
resp. a special studio! Should there be any
troubleswith your locoand shouldyoutherefore
have to send it to the factory for any reperations,
pleaseremoveany eventuallyinstalledmodules
before,as we will not be able to accept responsi-
bility for any non-ROCO-parts.
This locomotive
has been
Werbung
