Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TEX 140P, 140PS, 150PE, 180PS, 190PE, 220PS,
230PE, 270PS, 280PE
Start and stop
ON
Start the pneumatic breaker by pressing down the
start and stop device.
OFF
Stop the pneumatic breaker by releasing the start
and stop device. The start and stop device will
automatically return to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
♦
Press the machine against the working surface
before you start.
♦
Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
♦
Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool does
not get stuck.
© 2015 Atlas Copco Construction Tools AB | No. 9800 0683 82h | 2015-08-21
Original instructions
A
Safety and operating instructions
Breaking
♦
Let the machine do the work; do not press too
hard. The vibration-reducing handle must
absolutely not be pressed all the way down to the
base.
♦
For pneumatic breakers with vibration-reducing
handles: The feed force should be adapted so that
the handles are pressed down 'half way'. The best
vibration damping and breaking effect is achieved
at this position.
♦
Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar) which
would cause substantial vibrations.
♦
Any form of idling, operating without insertion tool
or operating with an uplifted machine must be
avoided.
♦
When the machine is lifted, the start and stop
device must not be activated.
♦
Check regularly that the machine is well lubricated.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
17
Werbung
