Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT
Conservation temperature is set at the
factory at 4°C.
Cleaning mode: hold down key (C) for three
seconds to enable CLEANING mode, during
which the display shows " --.-- ". In this mode, the
mixer turns but the cooling is not enabled. This
function is useful during machine rinsing, washing
and sanitising to prevent the contents of the unit
from being cooled. It is nonetheless always
possible to quit cleaning mode simply by pressing
any key.
Temperature adjustment in DRINK mode: the
optimal temper atur e of drinks (when the
dispenser works as a drinks cooler rather than as
an ice crusher) is factory set to 4°C. If you want to
adjust the temperature, hold down keys (C) and
(D) simultaneously for two seconds. The indicator
light (E) and the temperature set will flash and you
can adjust it using keys (C) and (D). The display
will go blank for a few seconds and then the
current temperature will be displayed.
M i n i m u m t e m p e r a t u r e a d j u s t m e n t i n
GRANITA mode: you can also adjust the
minimum temperature of the product when the
dispenser is operating in granita mode. This
minimum temperature is factory set to -10°C. If
you want to adjust it, hold down keys (C) and (D)
simultaneously for two seconds to go into drink
temperature adjustment mode and the indicator
light (E) will flash. Press keys (C) and (D) for two
seconds to go into granita minimum temperature
adjustment mode and the indicator light (F) and
temperature set will flash. You can adjust the
temperature using keys (C) and (D). The display
will go blank for a few seconds and then the
current temperature will be displayed.
To operate the unit :
1
Set the power switch to I position
2
Select :
-Button (C) to get cold drink ( without freezing it)
-Button (D) to get slush
Cleaning function: during sanitizing operations, it
may be useful to have the mixers turning , without
cooling. To get this, press for three seconds the
button (C ) : the display of thermostat will show "-
-.-- "
By pressing any button, the dispenser will get out
from cleaning function and will operate normally.
ELECTROMECHANICAL VERSION
All the switches are located on the faucet side of
the dispenser in switch panels protected by
All manuals and user guides at all-guides.com
17
switch covers (see figure 1).
figure 2
With reference to figure 3 dispenser controls
functions are as follows:
figure 3
Power switch (A)
0 position
: p ow er is tu rn ed OF F to a l l
functions.
I position
: p o w e r i s t u r n e d O N t o a l l
functions and the other switches
are enabled. The fan motor runs.
Mixer/refrigeration switch (B)
I position
: mixer and refrigeration ON.
SOFT DRINK mode.
0 position :
OFF.
II position : mixer and refrigeration ON.
GRANITA mode.
Thermostat (D)
Turn clockwise
: to decrease temperature
T u r n
: to increase temperature
counterclockwise
To operate the unit:
3
Set the power switch to I position.
Set the mixer/refrigeration switches as follows:
- to the I position to get soft drink.
- to the II position to get Granita.
7. 2 OPERATION HELPFUL HINTS
1
Granita
viscosity
Granita viscosity is factory preset. To change the
viscosity, if needed, use a standard screwdriver
to turn the adjustment screw located in the rear
adjustment:
proper
Werbung
