ABB FEX300 Schnittstellenbeschreibung Seite 6

HART Kommando-Übersicht
2.1.3 Command 2
Read Current and Percent of Range
Command 1
Request Data
Bytes
Response
Data Bytes
Response
Code
2.1.4 Command 3
Read all dynamic Variables and Current
Command 0
Request Data
Bytes
Response
Data Bytes
Response
Code
2.1.5 Command 6
Write Polling Address
Command 6
Request Data
Bytes
Response
Data Bytes
Response
Code
6
Mnemonic
None
Analog Output Current mA [Iout without Unit]
Percent of Range [Q in Percent ]
0 „No Command Specific Error"
5 „Incorrect Byte Count"
Mnemonic
None
Analog Output Current [Iout]
Primary Variable Unit Code
Primary Variable [Q in Unit]
Secondary Variable Unit Code
Secondary Variable [Counter Forward]
Tertiary Variable Unit Code (Table 2)
Tertiary Variable [Counter Reverse]
4th Variable Unit Code
4th Variable [Counter Differenz]
0 „No Command Specific Error"
5 „Incorrect Byte Count"
Mnemonic
Polling Adress of Device
Polling Adress of Device
0 „No Command Specific Error"
2 „Invalid Selection"
5 „Incorrect Byte Count"
FEX300, FEX500
Offset Size Datatype
- - -
#0 ... 3 4 FLOAT
#4 ... 7 4 FLOAT
Offset Size Datatype
- - -
#0 ... 3 4 FLOAT
#4 5 FLOAT
#5 ... 8
#9 5 FLOAT
#10 ... 13
#14 5 FLOAT
#15 ... 18
#19 5 FLOAT
#20 ... 23
Offset Size Datatype
#0 1 USIGN8
#0 1 USIGN8
COM/FEX300/FEX500/HART-DE