Audiotec Fischer match UP 1FX Bedienungsanleitung Seite 17

Configuration examples
Note: If you have activated the DirectDSP function, the crossover frequencies for the subsonic
or lowpass must be set in the preconnected DSP / DSP amplifier.
Zwei Subwoofer mit einer
Schwingspule
(Single Voice Coil)
Ein Subwoofer mit
Doppelschwingspule
(Dual Voice Coil)
Mono subwoofer application
Subwoofer with one voice coil (single voice coil)
RMS output power ≤ 1% THD+N:
1 x 4 Ohms: 350 Watts
1 x 2 Ohms: 600 Watts
1 x 1 Ohm: 900 Watts
Parallel operation
Two subwoofers with one voice coil (single voice coil) or one
subwoofer with dual voice coil are connected in parallel.
Note: The parallel connection of two voice coils will result in
halving the impedance!
RMS output power ≤ 1% THD+N:
Two subwoofers with 1 x 4 Ohms correspond to a total
impedance of 2 Ohms: 600 Watts
One subwoofer with 2 x 4 Ohms also corresponds to a total
impedance of 2 Ohms: 600 Watts
Two subwoofers with 1 x 2 Ohms correspond to a total
impedance of 1 Ohm: 900 Watts
One subwoofer with 2 x 2 Ohms also corresponds to a total
impedance of 1 Ohm: 900 Watts
Note: The parallel connection of 1 Ohm voice coils will result in
shutdown of the amplifier.
en
17