Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Congratulations!
Dear Customer,
Congratulations on your purchase of this innovative
and high-qual ity MATCH product.
Thanks to more than 30 years of experience in
research and development of audio products this
amplifier sets new standards in the range of am-
plifiers.
General instructions
General installation instructions for MATCH
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installation
instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect the
battery's negative terminal to prevent damage
to the unit, fire and / or risk of injury. For a proper
performance and to ensure full warranty coverage,
we strongly recommend to get this product installed
by an authorized MATCH dealer.
Install your UP 1FX in a dry location with sufficient
air circulation for proper cooling of the equipment.
For safety reasons, the UP 1FX must be profes-
sionally installed. Therefore, use the two mounting
plates which are included in delivery. These are at-
tached to the bottom of the amplifier with two short
screws which are included in delivery, too.
When screwing the amplifier to the vehicle chassis,
carefully examine the area around and behind the
proposed installation location to ensure that there
are no electrical cables or components, hydraulic
brake lines or any part of the fuel tank located be-
hind the mounting surface. Failure to do so may re-
sult in unpredictable damage to these components
and possible costly repairs to the vehicle.
We wish you many hours of enjoyment with your
new MATCH UP 1FX.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the UP 1FX
amplifier
The UP 1FX amplifier may only be installed in mo-
tor vehicles which have a 12 Volts negative terminal
connected to the chassis ground. Any other system
could cause damage to the amplifier and the electri-
cal system of the vehicle.
The positive cable from the battery for the entire
sound system should be provided with a main fuse
at a distance of max. 30 cm from the battery. The
value of the fuse is calculated from the maximum
total current draw of the car audio system.
Use only suitable cables with sufficient cable
cross-section for the connection of the UP 1FX.
The fuses of the amplifier may only be replaced
by identically rated fuses (2 x 30 A) to avoid
damage of the amplifier.
Prior to installation, plan the wire routing to avoid
any possible damage to the wire harness. All
cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
en
11
Werbung
