Grundig GEBM19301BC Installationsanleitung Seite 5

If the product will be placed to corner: (Figure 4a-4b)
• Attention should be paid to the dimensions given in order to make the corner installation in
the figure 4a and 4b.
4a
min.50
Connecting the appliance to the electricity supply
• Only connect the product to a grounded outlet/line with the voltage and protection as
specified in the "Technical specifications". Have the grounding installation made by a
qualified electrician while using the product with or without a transformer. Our company
shall not be liable for any problems arising due to the product not being earthed in
accordance with the local regulations.
• Before starting any work on the electrical installation, disconnect the product from the
mains supply. There is the risk of electric shock!
• The product must be connected to the mains supply only by an authorised and qualified
person. The product's warranty period starts only after correct installation. Manufacturer
shall not be held responsible for damages arising from procedures carried out by
unauthorised persons.
• The appliance must be installed so that it can be completely disconnected from the mains
supply. The separation must be provided by a switch built into the fixed electrical installation,
according to construction regulations.
• Rear surface of the oven gets hot when it is in use. Make sure that the electrical connection
does not come into contact with the rear surface otherwise, connections can get damaged.
• The connection cable must not be clamped,bent or trapped or come into contact with hot
parts of the oven. You may cause the oven to short circuit and catch fire as a result of the
cable melting. If the power cord is damaged, it must be replaced by a qualified electrician.
Otherwise there is a risk of electric shock, short circuit or fire!
• The plug of the power cord should be easily accessible after installation (but not over the hobs).
• When wiring, you must comply with national / local electrical regulations and use socket
outlet / line and plug suitable for the Oven. If the power limits of the product exceed the
current carrying capacity of the plug and socket outlet / line, you must connect the product
directly to the fixed electrical installation without using the plug and socket outlet / line.
• Make sure that fuse rating is compatible with the product.
• Connection must comply with national regulations.
• The mains supply data must correspond to the data specified on the type label of the
product. Open the front door to see the type label.
• Power cable of your product must comply with the values in "Technical specifications" table.
4b
min.50
min. 45
5