Bender ISOMETER isoCHA425HV AGH420-1 Kurzanleitung Seite 10

ISOMETER® isoCHA425HV + AGH420-1/AGH421-1
Technische Daten AGH420-1 und AGH421-1
Isolationskoordination nach IEC 60664-1/IEC 60664-3
Bemessungsspannung ................................................................ 1000 V
Überspannungskategorie .................................................................... III
Überwachtes IT-System
Netznennspannung U .....................................................DC 0...1000 V
n
Toleranz von U ............................................................................+10 %
n
Netznennspannungsbereich U
Einzelleitungen für Klemmen Up, AK1, GND, AK2:
Leitungslänge zwischen ISOMETER® und AGH ........................... ≤ 0,5 m
Querschnitt ..........................................................................≥ 0,75 mm
Sonstiges
Betriebsart ......................................................................... Dauerbetrieb
Einbaulage .............. Kühlschlitze müssen senkrecht durchlüftet werden
Schutzart Einbauten (DIN EN 60529) ............................................... IP30
Schutzart Klemmen (DIN EN 60529) ................................................ IP20
Schnellbefestigung auf Hutprofilschiene .................................IEC 60715
Schraubbefestigung ........................................ 2 × M4 mit Montageclip
10
(UL 508) ...........................DC 0...600 V
n
Technical data AGH420-1 and AGH421-1
Insulation coordination acc. to IEC 60664-1/IEC 60664-3
Rated voltage .............................................................................. 1000 V
Overvoltage category ........................................................................... III
Monitored IT system
Nominal system voltage U
Tolerance of U .............................................................................+10 %
n
Nominal system voltage range U
Single cables for terminals Up, AK1, GND, AK2:
Cable lenght between ISOMETER® and AGH .............................. ≤ 0.5 m
Cross section ........................................................................≥ 0.75 mm
2
Other
Operating mode ...................................................... continous operation
Mounting .............................. cooling slots must be ventilated vertically
Degree of protection, built-in components (DIN EN 60529) ............. IP30
Degree of protection, terminals (DIN EN 60529) .............................. IP20
DIN rail mounting acc. to ........................................................ IEC 60715
Screw mounting ......................................... 2 × M4 with mounting clip
..............................................DC 0...1000 V
n
(UL 508) .......................DC 0...600 V
n
2