Inhaltsverzeichnis
Werbung
1.
The recommended minimum thickness of the thermal
insulation in the walls is 50 mm and in the ceiling 100 mm.
2.
It is possible to use carton- or aluminum foil laminate as a
vapor barrier, which is affixed over the insulation aluminum
foil inwards.
3.
Leave at least 20 mm air slot between vapor barrier and
inside panel
4.
To prevent gathering of the moisture behind the panel, leave
the slot between wall panel and ceiling.
Heating of the sauna
CAUTION!
Smoke and odor formation when heating up for the first time
Work materials from the manufacturing process will be present on the
new heating elements. These evaporate when the sauna heater is
heated up for the first time. This produces smoke and an unpleasant
odor. Breathing in the fumes or smoke can be harmful to your health.
Perform the following steps when operating the sauna heater for the
first time and if the heating elements for the sauna heater have been
changed. In this way you will prevent damage to health due to the
fumes and smoke produced when heating up for the first time.
1.
Select the highest possible temperature in the sauna control.
2.
Heat up the sauna heater for half an hour. Do NOT stay in the sauna
cabin during this period.
Allow the sauna cabin to ventilate thoroughly after heating up for the
3.
first time.
4.
If no smoke or odor is produced the next time the sauna heater is
heated up, you can start to use the sauna. If smoke or odor is
produced again, leave the sauna cabin immediately and repeat the
initial heating up process followed by ventilation.
Always check the sauna room before switching sauna heater on (to be sure
that there is no combustible things within the safety distances of the
heater or on the heater). Make sure that sauna room has been efficiently
ventilated. If the output of the heater is proper it will take about an hour to
reach suitable temperature (Fig. 7). The temperature in sauna room should
be between +60 - + 90 °C, according to the preference of user. Too
powerful heater will heat sauna room too quickly and the stones won't have
enough time to warm. The water poured on the stones will not evaporate,
but flow into the stone holder. An underpowered heater, on the other hand,
would lead to an undesirably long heating period.
19
ENGLISH
Werbung
Inhaltsverzeichnis
