ELAC IW1030 Bedienungsanleitung Seite 17

Preparations for installation
2) After removing the front grille, unscrew the six
outer screws by means of the
driver.
Keep the screws in a safe place. You will use them
for later installations.
Do not touch the diaphragms of the drivers
when installing or removing the loudspeaker. If
the diaphragms are pressed too hard, they will
be damaged.
3) Remove the speaker unit by means of the grille
removal tool. Carefully insert the grille removal tool
into the little hole on the front of the speaker unit
and make sure that the speaker unit does not fall
down!
4) Disconnect the cables from the loudspeaker
terminals. Press on the terminal to remove the
cables.
Phillips hand screw
17