JUNO JGVX605E1 Benutzerinformation Seite 12

Water hardness
German French de‐
degrees grees (°fH)
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1)
Factory setting.
2)
Do not use salt at this level.
Regardless of the type of detergent used,
set the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt are not
effective enough to soften hard water.
Regeneration process
For the correct water softener operation, the
resin of the softener device needs to be
regenerated regularly. This process is
automatic and is the part of the normal
dishwasher operation.
When the prescribed quantity of water (see
values in the table) has been used since the
previous regeneration process, a new
regeneration process will be initiated between
the final rinse and the programme end.
Water softener lev‐
el
1
2
3
4
12 ENGLISH
mmol/l
84 - 90 8.4 - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
<7 <0.7
Amount of water
(l)
250
100
62
47
mg/l (ppm) Clarke
degrees
835 - 904 58 - 63
755 - 834 53 - 57
645 - 754 46 - 52
505 - 644 36 - 45
395 - 504 28 - 35
325 - 394 23 - 27
255 - 324 18 - 22
185 - 254 13 - 17
70 - 184
<70
Water softener lev‐
el
5
6
7
8
9
10
In case of the high water softener setting, it
may occur also in the middle of the
programme, before the rinse (twice during a
programme). Regeneration initiation has no
impact on the cycle duration, unless it occurs
in the middle of a programme or at the end of
a programme with a short drying phase. In
such cases, the regeneration prolongs the
total duration of a programme by additional 5
minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin in the
same cycle or at the beginning of the next
programme. This activity increases the total
Water soften‐
er level
10
9
8
7
6
1)
5
4
3
5 - 12 2
< 5
2)
1
Amount of water
(l)
25
17
10
5
3
3