JUNO JGVL608E2 Benutzerinformation Seite 24

Problem and alarm code
Malfunction of the water level de‐
tection sensor.
i41
The display shows
Malfunction of the wash pump or
the drain pump.
i51
The display shows
i5A i5F
- .
The temperature of the water in‐
side the appliance is too high or
malfunction of the temperature
sensor occurred.
i61
The display shows
Technical malfunction of the ap‐
pliance.
iC0
The display shows
The level of water inside the ap‐
pliance is too high.
iF1
The display shows
The appliance stops and starts
more times during operation.
The programme lasts too long.
The displayed programme dura‐
tion is different than the duration
in the consumption values table.
The remaining time in the display
increases and skips nearly to the
end of the programme duration.
Small leak from the appliance
door.
The appliance door is difficult to
close.
The appliance door opens during
the wash cycle.
24 ENGLISH
Possible cause and solution
• Make sure that the filters are clean.
• Switch the appliance off and on.
i44
- .
• Switch the appliance off and on.
i59
- or
• Make sure that the temperature of the inlet water does not exceed
60°C.
• Switch the appliance off and on.
i69
or .
• Switch the appliance off and on.
iC3
or .
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height above
.
the floor. Refer to the installation instructions.
• It is normal. It provides optimal cleaning results and energy savings.
• If the delay start option is set, cancel the delay setting or wait for the
end of the countdown.
• Activating options can increase the programme duration.
• The pressure and the temperature of the water, the variations of the
mains supply, the options, the quantity of dishes and the degree of
soil can change the programme duration.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if
applicable).
• The appliance is not levelled. Loosen or tighten the adjustable feet
(if applicable).
• Parts of the tableware are protruding from the baskets.
• The AirDry function is activated. You can deactivate the function.
Refer to
"Basic settings"
.