JUNO JGVL608E2 Benutzerinformation Seite 16

8.2 How to fill the rinse aid dispenser
CAUTION!
The compartment (B) is for rinse aid only.
Do not fill it with detergent.
9. DAILY USE
1. Open the water tap.
2. Press and hold
activated.
3. Fill the salt container if it is empty.
4. Fill the rinse aid dispenser if it is empty.
5. Load the baskets.
6. Add the detergent.
7. Select and start a programme.
8. Close the water tap when the programme
is complete.
9.1 Using the detergent
A B
C
16 ENGLISH
A B
C
until the appliance is
CAUTION!
Only use rinse aid designed specifically
for dishwashers.
1. Open the lid (C).
2. Fill the dispenser (B) until the rinse aid
reaches the marking ''MAX''.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent excessive
foam formation.
4. Close the lid. Make sure that the lid locks
into position.
Fill the rinse aid dispenser when the
indicator (A) is clear.
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (A) to open the
lid (C).
2. Put the detergent (gel, powder or tablets)
in the compartment (B).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the lid locks
into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
The upper ends of the two vertical
ribs inside the compartment (B) indicate
the maximum level for filling the
dispenser with gel (max. 30ml).